Area Preparation All wood surfaces must be thoroughly clean, dry and free of dirt, grease, grime, mildew, mill glaze and previous coatings before application. Exotic hardwoods such as maple, mahogany, ironwood, tigerwood and teak exhibit a dense cell structure which may reduce the ability of a coating to penetrate the wood surface; refer to the water absorbency test in the APPLICATION section to determine if surface is ready for finishing. Application Details Apply using a high quality natural bristle brush. First coat must be applied to all six sides, saturating all end grains, nail holes and cracks in the wood. Apply an even coat, in the direction of the wood grain, avoiding heavy application. Maintain a wet edge to avoid lap marks. Wait 24 hours before applying the second coat. TWO COAT APPLICATION IS RECOMMENDED FOR OPTIMAL PERFORMANCE. Apply when air and surface temperature is between 50°F (10°C) to 90°F (32°C). Do not apply in direct sunlight, if rain, snow, heavy dew or low temperatures below 40°F (4°C) are expected within 48 hours. Drying Time Normally dries to touch and recoat in 24 hours at 77°F (25°C) and 50% relative humidity. Allow 72 hours before light foot traffic. Wait seven days after applying the second coat to replace furniture. Drying times listed may vary depending on temperature, humidity, color, film build and air movement. Coverage On smooth surfaces, 350 to 450 sq. ft. (33–42 sq. meters) per U.S. gallon (3.78 L). Actual coverage may vary depending on the type, age and texture of the wood and application method. Cleanup Clean tools immediately with mineral spirits. Clean spills right away with a damp cloth. DANGER – RAGS, STEEL WOOL OR WASTE SOAKED WITH THIS PRODUCT MAY SPONTANEOUSLY CATCH FIRE IF IMPROPERLY DISCARDED. IMMEDIATELY AFTER EACH USE, PLACE RAGS, STEEL WOOL OR WASTE IN A SEALED WATER-FILLED METAL CONTAINER.