Area Preparation Please refer to the Product Label, Technical Data Sheet (TDS) or Safety Data Sheet (SDS) for detailed application and safety instructions. Application Details Both wood and concrete surfaces must be completely dry before beginning to apply Revitalize. Stir product thoroughly. Apply with high quality brush and/or ½” nap roller. Two coats are required. Before applying first coat, dab a heavily loaded brush into cracks, gaps, nail/screw holes and knots until filled. For cupped, cracked or warped boards, drive product into cracks by rolling across the narrow width as well as the length of the board. Lightly brush any product that drips between the boards. Cut in around the edges of the deck or concrete surface with a brush using a short dabbing stroke. To apply the first coat, fully saturate the roller by rolling back and forth in the tray. A fully-loaded roller will cover an area of approximately 5-7 sq. ft. Using light and even pressure, apply product to a few boards or a few square feet at a time, keeping a wet edge to avoid lap marks. Lightly backbrush after rolling for a smoother appearance. Please use caution when applying around aquatic habitats to avoid spills. To apply second coat, cut in around edges of entire surface again and roll out like the first coat. Apply Revitalize when air and surface temperatures are between 50 - 90 degrees F for 24 hours (day and night). Do not apply if rain is expected within 24 hours of each coat. Drying Time Drying times will vary depending on weather and condition of surface. Allow minimum of 6 hours for the first coat to dry. Allow final coat to dry 48 hours before foot traffic and 72 hours before replacing furniture or heavy objects. Cool or humid conditions require longer drying time. If surface remains tacky, allow more time to dry. Premature use will cause coating to fail. Avoid heavy use for 30 days to allow full cure to hard finish. Coverage Up to 75 sq. ft. (6.97 sq. meters) per U.S. gallon (3.78 Liters) in 2 coats. Coverage figures do not include material loss due to application. Cleanup Clean tools with warm soapy water.